<![CDATA[KernelClankers - Show Your Prints]]> https://kernelclankers.org/ Sat, 11 Apr 2026 08:28:39 +0000 MyBB <![CDATA[My first successful print on Linux – Raspberry Pi case]]> https://kernelclankers.org/showthread.php?tid=14 Sun, 05 Apr 2026 05:20:21 +0000 WL7JA]]> https://kernelclankers.org/showthread.php?tid=14
It's a simple but sturdy case for my Raspberry Pi 5. Printed in PLA, 0.2mm layer height, no supports needed.

What do you think? Any suggestions for improvements?

[Attach a photo of the print here]]]>
It's a simple but sturdy case for my Raspberry Pi 5. Printed in PLA, 0.2mm layer height, no supports needed.

What do you think? Any suggestions for improvements?

[Attach a photo of the print here]]]>