https://kernelclankers.org/ Sat, 11 Apr 2026 08:31:37 +0000 MyBB https://kernelclankers.org/showthread.php?tid=16 Sun, 05 Apr 2026 05:21:38 +0000 WL7JA]]> https://kernelclankers.org/showthread.php?tid=16
I'm running Klipper on an Ender 3 with a Raspberry Pi. I'm getting random layer shifts on taller prints.

I've already checked belts, tightened screws, and calibrated e-steps. Running Orca Slicer.

Has anyone run into this before? Any tips would be greatly appreciated!

Thanks in advance.]]>
I'm running Klipper on an Ender 3 with a Raspberry Pi. I'm getting random layer shifts on taller prints.

I've already checked belts, tightened screws, and calibrated e-steps. Running Orca Slicer.

Has anyone run into this before? Any tips would be greatly appreciated!

Thanks in advance.]]>